Photo: Julian Wass
«»
You can make a roomy, reclining seat with a fan back and wide armrests out of weather-resistant decking lumber
Overview
Introduction
Overview
Step 1
Assemble the Base
Step 2
Start the Seat
Step 3
Make the Back
Step 4
Attach the Arms
Step 5
Attach the Slats
More in Interior
Tools List
-
Jigsaw
-
Drill/driver
Shopping List
1. 6-inch pressure-treated decking You'll need about seven 6-footers to make the back slats, arm rests, seat supports, seats slats and front crosspiece.
2. 4-inch pressure-treated decking Pick up two 6-footers to construct the back braces, front legs, and blocking for the arm rests.3. 1-inch pressure-treated baluster You'll need 44-inches of material for two 22-inch raisers to support the back braces.
4. 100-grit sand paper
5. 2-inch deck screws
2. 4-inch pressure-treated decking Pick up two 6-footers to construct the back braces, front legs, and blocking for the arm rests.3. 1-inch pressure-treated baluster You'll need 44-inches of material for two 22-inch raisers to support the back braces.
4. 100-grit sand paper
5. 2-inch deck screws
Contribute to This Story Below