Q: I know that foam insulation is popular with you guys. But as an electrician, I'm concerned that it limits options for any future wiring. Once it's in place, how can I snake wires through those walls if the homeowner wants to put in another circuit or add a switch or receptacle?

— David, Newton, Mass.

A: Tom replies: We've used polyicynene foam insulation on a number of projects because it doesn't trap moisture, is environmentally safe, muffles sound, and seals every crevice where air might leak in or out. Basically, we figure the benefits far outweigh the difficulty it might cause when making future wiring changes. Actually, because the insulation is fairly soft and forgiving, retrofitting wiring isn't as bad as you think. On a recent project where we had to run wires from the basement into an upstairs home office, we drilled through the subfloor and wall plate, then pushed a fish tape right up through the foam. It wasn't the easiest way to go, but I'm sure you've found that snaking wires through fiberglass batts can be a challenge, too. Still, we do try to anticipate the problems future electricians might face. In some cases, we've put lengths of electrical conduit vertically in the walls and capped both ends before filling them with foam. This way, wires can be routed easily from one level to the next if anyone ever wants to.
Ask TOH users about Electrical

Contribute to This Story Below