It's easy to have a glass shop or hardware store cut replacement glass for you. But when you're replacing a pane in an old sash, the perfection of new glass will look out of place next to the wavy, bubble-filled originals. That's why Tom Silva makes a habit of saving old (pre-1950) glass from windows that are being tossed out. Then he just cuts his own as he needs it. Here's how:

Step 1: Lay the glass on the sash and line up one corner of the glass with a corner of a clean, putty-free opening. Leave the edge of the glass about 1/16 inch from the inside edges of the rabbets.

Step 2: Place a framing square on top of the glass and line it up with the inside edges of the rabbets in the opposite corner, which are visible beneath the glass.

Step 3: Lubricate the glass cutter's tiny wheel with a drop of oil.

Step 4: Holding the square firmly in place, set the side of the cutter against one side of it. Holding the cutter in a vertical position, pull it over the pane's surface with a single firm stroke. (You've only got one chance.) Listen for a continuous scratchy, crackling sound. If there's no sound, try again in a different part of the glass, bearing down a bit harder. Or buy a new cutter. Score only one side of the corner in this step.

Step 5: With gloved hands, line up the score line with the edge of a table.

Step 6: Grip the side hanging off in space and snap the pieces apart with a slight downward flick of the wrist.

Step 7: Take the glass back to the sash, line it up as before, and with the square in place, score the other side of the corner. Break as above.

Ask TOH users about Hand Tools

Contribute to This Story Below